Sanyo PLC-EF60 - Manual (Page 67)

67
Maintenance and Cleaning
Maintenance & Cleaning
READY
Green
LAMP
Red
WARNING
TEMP
Red
Indicators
The projector is OFF. (The AC power cord is unplugged.)
The projector is preparing for stand-by or the projection lamp is being cooled
down. The projector cannot be turned on until cooling is completed.
The projector is operating normally.
The projector is in the Power management mode.
The temperature inside the projector is abnormally high. The projector cannot
be turned on. When the projector is cooled down enough and the
temperature returns to normal, the LAMP indicator lights red and the projector
can be turned on.
The projector detects an abnormal condition and cannot be turned on. Unplug
the AC power cord and plug it again to turn on the projector. If the projector is
turned off again, disconnect the AC power cord and contact the dealer or the
service center for service and checkup. Do not leave the projector on. It may
cause electric shock or a fire hazard.
The projector is ready to be turned on with the POWER ON-OFF button.
The projector has been cooled down enough and the temperature returns to
normal. When turning on the projector, the WARNING TEMP indicator stops
blinking. Check and clean the air filters.
Projector Condition
• • • Off • • • Dim lighting • • • Lighting • • • Blinking LED Conditions:
Main Indicators
Indicators and Projector Condition
READY, WARNING
TEMP, SHUTTER,
WARNING FILTER, LAMP
1 REPLACE AND LAMP 2
REPLACE indicators are
blinking all together.