Sony TAV-L1 - Manual (Page 24)

24 US
Programming the
remote control
The remote control is preset to operate Sony
brand equipment.
Follow the steps below to program your system’s
remote control to operate the other equipment.
Find the three-digit code for your equipment from the
“Manufacturer’s Codes” listed on page 25. If more
than one code number is listed, try entering from the
code listed first.
1
Press and hold the CABLE or SAT
(FUNCTION) you want to program and
press POWER simultaneously.
The selected FUNCTION button (CABLE or
SAT) will flash.
2
Enter the three-digit manufacturer’s code
number using the number buttons while
the button is lit, approximately 30
seconds.
3
Press ENT.
When the programming is correct, the selected
FUNCTION button will flash twice slowly, and
when not, flashes five times quickly.
To check if the code works
Aim your system’s remote control at the
equipment, and press
POWER . If the equipment
responds, the programming is completed. If not,
try the next code listed.
Notes
• If no code is input within the above specified time, or an
invalid or incorrect code number is input, the remote
control automatically goes back to the previous setting.
• In some cases, you may not be able to program your
remote control to operate other equipment. In such cases,
use the equipment’s own remote control.
• Dead batteries or removing the batteries may cause the
programmable codes to be lost and revert back to factory
settings. Reprogramming the codes may be necessary.
Enjoying the Connected Equipment
FUNCTION
buttons
Number
buttons
ENT
POWER
Sony Equipment Programmable Code Number
Cable 101 (DVR)
Satellite receiver 201 (DSS)