Sony AT107 - Manual (Page 27)

27
H
ook
up
s and
Se
tti
n
gs
External Receiver 1/External
Receiver 2/External Receiver 3 (only
when connecting the set top box
receiver)
1
Press ENTER to select “Continue.”
2
Select the set top box receiver type
using
M/m, and press ENTER.
3
Select the provider using M/m, and
press ENTER.
4
Select the receiver brand using M/
m, and press ENTER.
If you select “Other providers,” you
can select a receiver brand from a
list of all available brands.
If your receiver brand is not on the
list, select “???.”
The receiver brand list is
automatically updated, so your
receiver may be available at a later
date. Select your brand when it
becomes available. Until then, use
“???.”
5
Select the connection you used for
your set top box receiver using
M/
m, and press ENTER.
When the set top box receiver is
connected to the recorder using
hookup A with both an aerial cable
and a SCART cord, select either
“Line1” or “Antenna.”
The display asks for confirmation.
6
Press ENTER to select “Continue.”
The Video Window switches to the
specified programme position.
7
Select “YES” using M/m, and press
ENTER.
The display asks for confirmation.
If the Video Window does not
switch to the specified programme
position, select “NO” and press
ENTER until the Video Window
switches to the specified
programme position.
3
Turn off the recorder to receive GUIDE
Plus+ system data.
b Note
You cannot set tuner system or “OSD Language”
to a country/region or language that is not
supported by the GUIDE Plus+ system.
If you cannot get the recorder to control
your set top box receiver
Check the connection and position of the set
top box controller (page 16).
If your set top box receiver still does not
operate with this recorder, refer to the
instructions supplied with your set top box
receiver and contact your cable or satellite
company to see if they can provide you with
a compatible set top box receiver.
b Notes
• The list of external receivers controllable by the
GUIDE Plus+ system is updated constantly and
is distributed through GUIDE Plus+ system data
signals. Since the time your recorder has been
produced and the time you installed your
recorder for the first time, new external receiver
codes might have been added.
• If the external receiver is still not on the list or is
not controlled properly by the recorder, please
call Customer Support to report the brand and
model of your external receiver.
To receive GUIDE Plus+ system
data your recorder must be turned off
when not in use. If your recorder is
connected to a set top box receiver,
be sure to leave the set top box
receiver turned on. After initial
setup, it may take up to 24 hours to
begin receiving TV programme
listings.
,continued