Sanyo AHX0752 - Manual (Page 70)

3-8
Trouble Diagnosis
1
2
3
4
5
6
7
8
3. W-2WAY ECO-i Alarm Codes
E25 Alarm
Alarm code E25
—
—
—
—
Alarm meaning Outdoor unit address setting failure (duplication)
Alarm conditions Communication by the outdoor unit main/sub control wiring was received that contained the
same address as that unit 5 times or more within 3 minutes.
Probable cause The unit number is set incorrectly.
Check Check the unit number again.
Correction Correct the incorrect unit number setting.
Example
Notes Recovery from this alarm occurs automatically (when communication that contains the same
address is not received for 3 minutes).
E26 Alarm
Alarm code E26
Alarm meaning Mismatch in outdoor unit quantity
Alarm conditions After power initialization, the set outdoor unit quantity did not match the number of outdoor units
detected on the outdoor unit main/sub control wiring for 3 minutes or longer.
Probable cause (1) The outdoor unit quantity is set incorrectly.
(2) The outdoor unit main/sub control wiring is cut.
Check (1) Check the outdoor unit quantity setting again.
(2) Check the outdoor unit main/sub control wiring.
Correction (1) Correct the incorrect outdoor unit quantity setting.
(2) Repair the outdoor unit main/sub control wiring.
Example
Notes
Recovery from this alarm occurs automatically (when the set outdoor unit quantity matches the
number of outdoor units detected on the outdoor unit main/sub control wiring).
E29 Alarm
Alarm code E29
Alarm meaning Outdoor unit (sub) failed to receive signal from outdoor unit (main).
Alarm conditions Outdoor unit (sub) communications from outdoor unit (main) were interrupted for 3 minutes or longer.
Probable cause (1) After initial communications were completed, the outdoor unit main-sub control wiring was
cut.
(2) After initial communications were completed, the RC connector (CN006) became disconnected.
(3) The power at the outdoor unit (main) is turned OFF.
Check (1) Check the outdoor unit main/sub control wiring.
(2) Check the RC connectors.
(3) Check the power at the outdoor unit (main/sub).
Correction (1) Repair the outdoor unit main/sub control wiring.
(2) Correct the RC connector connection.
(3) Turn ON the outdoor unit (main/sub) power.
Example
Notes