Sennheiser 2015 - Manual (Page 30)

82
Adjustment tips for the operating menu of the
transmitter
Adjusting the microphone sensitivity
SENSIT (MIC) Via the “ SENSIT (MIC)” menu, you can adjust the sensitivity of the con-
nected microphone in 32 steps. The microphone sensitivity is correct
adjusted when the display for microphone level (MIC)
ቤ shows full deflec-
tion only when you speak very loudly. The yellow LED ᕥ should only light
up briefly.
Note:
For monitoring the adjusted microphone sensitivity, the display for
microphone level (MIC)
ቤ is always indicated – even when the micro-
phone is muted.
Adjusting the sensitivity of the line input
SENSIT (LINE) Via the “ SENSIT (LINE)” menu, you can adjust the sensitivity of the line
input in 32 steps.
The input sensitivity is adjusted too high when loud passages cause over-
modulation in the transmission link. In this case, the yellow LED
ᕥ will light
up for longer periods of time. If, on the other hand, the sensitivity is
adjusted too low, the transmission link will be undermodulated, which
would result in a signal with high background noise.
The sensitivity is correctly adjusted when the display for line level (LINE) ባ
shows full deflection only during the loudest passages.
Note:
If the sensitivity of the line input is set to “OFF”, the display for line level
(LINE)
ባ is not shown on the display panel.
ቤ
´
ባ