Sony TC-TX373 - Manual (Page 6)

6
5
Connect A to A, and B to B using
the audio connecting cords. Insert the
plugs into jacks of the same colour.
The two audio connecting cords are the
same, so you can connect A or B using
either cord.
TC-TX373 rear panel
TAPE
L
R
A B
A B
IN OUT
DHC-MD373 rear panel
TC-TX373 rear panel
TAPE
L
R
IN OUT
A B
A B
DHC-MD333 rear panel
L : sound flow
* A l A
The sound signals of the CD, MD and TUNER
flow through the DHC-MD373/333 to the tape
deck when you record to tape.
** B l B
The sound signal of the tape deck flows to the
DHC-MD373/333 when you play a tape.
Connection to the DHC-MD333
4
(DHC-MD333 only)
Firmly connect the AU BUS connecting
cable to the AU BUS jack on the
DHC-MD333.
B
A
B
A
TC-TX373
DHC-MD333
Insert the
connector firmly
all the way.
Note
The AU BUS connecting cable is used for exchanging
signals between the tape deck and the DHC-MD333.
If you do not connect the cable firmly, the tape deck
and DHC-MD333 may not operate correctly.
Hooking up the system
(continued)