Siemens CP 343-1 - Manual (Page 22)

6 Configuring and Programming the CP as a PROFINET IO Device
B3L−22
CP 343-1 Lean for Industrial Ethernet / Manual Part B3L
Release 03/2007
C79000-G8976-C198-04
6.3 Configuration
Configuring the CP as a PROFINET IO device involves the two following activities
in STEP 7:
1. The CP is inserted in a SIMATIC 300 station in HW Config and enabled for
PROFINET IO device mode in the properties dialog.
2. The CP is assigned to a PROFINET IO controller as a PROFINET IO device in
HW Config.
Notice
These two configuration steps can be taken independently in HW Config. In both
steps, make sure that the configured device name for the PROFINET IO device
matches exactly.
6.3.1 Installing the CP and Specifying it as PROFINET IO Device
Follow the steps below in STEP 7 / HW Config:
1. Take the required CP from the hardware catalog and insert the module in the
SIMATIC 300 station.
Figure 6-2 Inserting the CP in a SIMATIC Station in HW Config