Samsung VP-D200(i) - Manual (Page 34)

Adjusting the LCD during PLAY
✤ You can adjust the LCD during playback.
✤ The adjustment method is the same procedure as used in CAM mode.
(see page 31)
The Speaker works in PLAYER mode only.
■ When you use the LCD screen for playback, you can hear recorded sound
from the built-in Speaker.
-
Follow the instructions below to decrease or mute
speaker volume in the PLAYER mode.
- Take the following steps to lower the volume or mute
the sound while playing a tape on the camcorder.
1. Set the power switch to PLAYER mode.
2. Press
(PLAY/STILL) to play the tape.
3. When you hear sounds once the tape is in play,
use the MENU SELECTOR to adjust the volume.
■ A volume level display will appear on the LCD.
Levels may be adjusted from anywhere between
00 to 19 and you will not hear any sound when the
volume is set on 00.
■ If you close the LCD while playing, you will not hear
sound from the speaker.
Notes
■ When the cable is connected to the AV jack, you cannot
hear sound from the speaker and cannot adjust the
volume.
■ If a cable is connected to the AV jack, you can hear sound
from the speaker when AV IN/OUT MODE on MENU is
set to AV IN. (VP-D200i/D230i/D250i/D270i only)
■ You can hear sound from speaker by removing the
connected cable from the AV jack.
Basic Recording
34
ENGLISH
Controlling Sound from the Speaker
PLAY
✤
✤ CAM 31
PLAYER
■ Speaker
- PLAYER
-
1. PLAYER
2. (PLAY/STILL) /
3. MENU
SELECTOR
■
00 19
00
■
■ A/V
■ MENU AV IN/OUT MODE
/ AV IN
A/V
VP-D200i/D230i/D250i/D270i
■ A/V
0 : 2 3 : 4 7
5 5 min
1 0 : 0 0
10 . J A N . 2 0 0 3
VOL. [ 1 1 ]
<3-2>
FADE
BLC
TAPE
EJECT OL/MF
MENU
S.SHOW
FADE
BLC
TAPE
EJECT
VOL/MF
MENU
S.SHOW
FWD
2
3-1