Siemens 54 - Manual (Page 10)

8
Installing the Gigaset USB Adapter 54
Gigaset USB Adapter 54 / englisch / A31008-M1071-R101-1-7619 / installation.fm / 04.12.2006
Status display
The Gigaset USB Adapter 54 has two LED displays.
Installing the software
First, the software included in the scope of delivery must be installed. This software not
only includes the driver software for the USB device, it can also be used as a
configuration and monitoring tool, the Gigaset WLAN Adapter Monitor.
Only this software has been written especially for the Gigaset USB Adapter 54. There are
similar drivers available in the Windows driver database. But, as a rule, such drivers do
not fully cover all the features or function in a different manner.
Do not connect the Gigaset USB Adapter 54 to your PC until prompted by the installation
program. If you connect the Gigaset USB Adapter 54 to your PC before installing the
software, Windows will automatically recognise the device and show the dialog box
prompting for the appropriate driver. Click on Cancel to close the dialogue. Remove the
Gigaset USB Adapter 54 from the PC and install the software.
LED State Meaning
Power Continuously
lit The Gigaset USB Adapter 54 was installed
successfully on your PC and is ready for operation.
Off The device is not ready.
WLAN Flashing Data is being transmitted.
Off There is currently no data traffic.
Please remember:
Do not insert the USB cable plug into a spare USB port on your PC until the
installation software prompts you to do so.
Please remember:
You may require administrator rights for the installation process on your PC.
Important Note!
If software for another WLAN device (such as another WLAN PC card or another
WLAN USB adapter) has already been installed on your PC, you have to uninstall this
software first and then reboot your PC before you install the Gigaset USB Adapter 54
software.