Siemens 300 - Manual (Page 47)

47
Appendix
Gigaset USB Adapter 300 / multilanguage / A31008-M1066-R101-2x-7619 / appendix.fm / 14.11.2008
Sc
hablone 200
4_12
_27
The connection is
not set up at all or is
not set up correctly. If you cannot establish a connection between your PC with the
Gigaset USB Adapter 300 and another wireless network
adapter, this may be due to a number of reasons:
The PC you want to connect to has not been powered up.
ì
Power up the PC.
The transmission speed set does not match that of the partners
in the network.
ì
Check whether you have set a particular transmission
speed. If this is the case, change to "Auto" (infrastructure
mode).
You are working in an ad-hoc network and a different radio
channel is being used.
ì
Select the correct radio channel.
The wrong mode has been set (infrastructure or ad-hoc mode).
ì
Select the correct mode.
The SSIDs of the devices that are to communicate with each
other do not match.
ì
Make sure that all connection partners with network adapt-
ers use the same SSID for wireless operation.
Different encryption methods are used.
ì
Select the same encryption method on all devices.
Changes in the configuration are not applied by your PC
ì
Reboot your PC.
The IP address or the subnet mask is configured incorrectly.
ì
Make sure that the IP address and the subnet mask are con-
figured correctly on the IP Settings tab.
As a rule, it is necessary to assign static IP addresses when
operating a network in ad-hoc mode.
Problem Causes and remedies