Sony MKE-9020M - Manual (Page 15)

1-9
MVE-9000 IM
7. Fix the rack angles in the rack using the specified
screws.
8. Install the front panel to the equipment.
Rack
Rack angle
Rack angle
B5 x 12
B5 x 12
3. Attach the right and left adaptors to the rack complete-
ly using the specified six screws.
(The illustration below shows the left adaptor.)
4. Tighten the screws (B4 x 6 : two screws each on the
right and left) for adjusting the length of the adaptor
completely (the screws that were loosened in step 2).
5. Align the groove of the rack tool at the side of the
equipment with the rail, and slide the equipment to the
rear.
n
The rack tools are hooked on the rails as shown below.
6. Remove the front panel. (Refer to Section 1-4-1.)
B4 x 10
3U
B4 x 10
31.75
31.75
Unit : mm
Rack tool Rack tool
Rail Rail