Sanyo HT27547 - Manual (Page 36)

36
MENU OPTION— CH (CHANNEL) SCAN MEMORY
Cannot select or scan some
channels. ● Channels may be removed from
memory.
● Check antenna connections.
● NO digital signal being broadcast.
● Weak Signal.
● V-Guide is set to block program-
ming.
● Select Channel Scan memory and
manually add channels or start an
“All Channel Search.”
● Turn antenna, install signal
booster.
● Set V-Guide to “Off” or press
RESET key to clear all settings and
restart channel search.
HELPFUL HINTS (PROBLEMS/SOLUTIONS)
SYMPTOM CHECK THESE CONDITIONS TRY THESE SOLUTIONS
If you continue to experience problems, please call toll free
1-800-877-5032. We can Help!
3 Use the numerical 0 ~ 9 keys to select desired
channel. “Add?” will appear beside the channel
number. HINT: Press the TUNER key to switch
between Digital and Analog Channel Scan memo-
ries.
4 Press the ENTER key to add the channel. The
display will change to “added.”
1 Press the MENU key to display the Main menu.
2 Use the CURSOR
▲▼ keys to highlight CH Scan
Memory. Press ENTER.
ADDING DIGITAL OR ANALOG
CHANNELS TO MEMORY
Channel Scan Memory is a list of active channels that
you can scan through using the Channel Scan CH
▲
(up) CH
▼ (down) keys. This list can be customized by
deleting and/or adding channels.
After 3 seconds the TV screen will display “Delete?”
OPERATING TIP:
■
If one digital sub-channel is added back to the
Channel Scan Memory list, all of that channel’s
sub-channels will be added back.