Kohler Tellieur 86216 2 BA - Manual (Page 2)

86216Ć2Ć BA (Ć) 2 Kohler Co., Kohler, WI
WALLĆMOUNT INSTALLATION
4.
Determine the desired location
of the storage cases.
Measure down 3Ć1/8" from
where the top edge of the
storage case will be located and
2Ć1/4" in from where the left
edge will be located. Make a
mark at this point.
While holding the cleat with the
largest side facing away from the
wall align the left hole in the
cleat with the mark on the wall.
Make sure cleat is level and
predrill holes into the wall to
align with the holes in the cleat.
Use a drill of adequate diameter
to accommodate fasteners (not
provided).
Secure cleat to wall with
appropriate fasteners/inserts
(not provided).
Storage Case
Cleat
2Ć1/4"
3Ć1/8"
5.
Position the storage case on the
wall so the top cleat that is
preĆinstalled on the back of the
cabinet rests on the cleat on the
wall. Make sure that the storage
case is centered on the cleat.
Measure 3/4" up from the
bottom inside edge and
approximately 3" from either
side. Drill a hole at each location
through the back of the storage
case, bottom cleat, and into the
wall.
Secure with fasteners (not
provided).
PreĆInstalled
Cleats
Storage Case
Wall
Cleat
Finished Wall