Kawasaki BRUTE FORCE R8126 - Manual (Page 10)

10
• Insert two #10 x 1" screws into the clip and tighten.
• Turn the vehicle upright.
13
• While holding the handlebar in place, carefully turn the vehicle over.
• Make sure the end of the steering column is through the hole in the
steering linkage.
• Fit the steering column cap onto the end of the steering column.
• Insert a #8 x 3 /
4
" screw through the large opening in the steering
column cap and into the hole in the steering column.
Tighten the screw.
Steering Column Cap
BOTTOM VIEW 10
11
• Slide the clip (open side down) under the end of the steering
column, as shown.
Clip
12
R8126a-0920