Kerio Tech Network Monitor - Manual (Page 21)

5.3 Initial Configuration
21
cation (Installed (APP) — in Windows 9x/Me) or is not installed as service (Not installed
(SVC) ).
Start Runs the service (if stopped).
Reinitialize the service Reinitialization of the service (de facto stopping and rerun-
ning) — only when the service is already running.
Stop Stops the service (if running).
Install as system service Creates the Kerio Network Monitor service, if it already does
not exist (in Windows NT/2000/XP as system service, in Windows 9x/Me as back-
ground application).
Remove the KNM service Removes the Kerio Network Monitor system service. The ser-
vice can be removed only when the service exists in the system and is stopped.
Warning: If the Kerio Network Monitor Daemon is installed as the service in the operating
system Windows NT/2000/XP, it is possible to start, stop and restart the service also
using the system Control Panel Services.
5.3 Initial Configuration
If you login to the viewer for the first time (after installation of Kerio Network Monitor),
a special dialog for selection of the adapters, on which the packets will be monitored, is
displayed..
Check the checkbox in front of all of the adapters you want to monitor. Usually it
should include all the adapters connected to the local network. There is usually no use
of monitoring the packets on the adapter connected to the Internet