Kerio Tech Network Monitor - Manual (Page 28)

Chapter 6 Configuration
28
List of services The window shows the list of the defined services (in the default set-
tings, there is already predefined the majority of the standard services). The columns
of the list have the following meaning:
• Service — name of the service (given by its definition)
• Protocol — protocol, which the service uses (TCP, UDP, ICMP, PPTP or any— All)
• Port / Subprotocol — port, which is used by the service (only for the TCP and UDP
protocols)
• Flags (flags) — indication of other parameters, which were set for the service.
Details see later.
The buttons under the list of the services allow definition of new service (Add), modifi-
cation of the service settings (Edit) or deleting of the service (Remove).
The arrow buttons (up / down) serve for ordering the services in the list. This order is
important only for better orientation; it has no influence to the function of the program.
Note: With some of the predefined services (HTTP, SMTP, POP3, IMAP4, FTP and DNS)
are connected some other functions of Kerio Network Monitor, and therefore they can
not be removed.
Service Definition
After pressing the Add or Edit button, the dialog for service definition will be shown: