Kerio Tech Network Monitor - Manual (Page 44)

Chapter 7 Viewing and Analysis of Captured Data
44
Note: If the packet with the same IP address is detected anytime afterwards, the
computer will be automatically included again.
New group Creates a new group. The dialog for a creation or a change of a group
contains the following parameters:
• Group name — name of the group. It should be sufficiently descriptive (i.e. it
should reflect, in general, the type of computers that will be included in this
group).
• Add newly recognized computers — when this option is checked, all new detected
computers (IP addresses) from a specified subnet will be automatically added to
this group. Enter the requested subnet with the appropriate mask.
Note: This option can be checked for several groups simultaneously, even for the
same subnet.
Remove the group Remove the selected groups from the list. This option does not
delete the computers which belong to the group, it only cancels their membership in
this group.
Group members A simple dialog that can be used to add or remove computers from/to
the selected group.
Group properties A dialog for a change of parameters of the selected group (identical
to the dialog for creation of a new group — see above).
Sorting of list of computers The last three options in the menu determine sorting of
the list of computers: by names (Sort by names), by IP addresses (Sort by addresses)
or by a transferred data volume in a descending order (Sort by traffic).