Operating the receiver, Volume, balance and tone settings – Kathrein UFD 346 User Manual
Page 12
Operating the Receiver
12
This menu is displayed
ADR – Category Selection
Button '1' : CLASSIC
Button '2' : POP
Button '3' : OLDIES
Button '4' : ROCK
Button '5' : JAZZ
Button '6' : COUNTRY
Button '7' : SPECIALITY
Button '8' : REGIONAL
Button '9' : NEWS/EVENTS
Button '0' : GENERAL
•
Use the number
buttons to select the desired category.
The receiver will switch to the next channel in this category.
The following is displayed on the screen:
Category mode
selected
Channel selection is now made with these
buttons, and no longer with the
number buttons.
Not all of the program suppliers categories will be shown in the OSD window. If the
selected category is not available, the following is displayed:
Selection
does not exist!
This selection is not possible.
•
Press this button
three times to exit the category mode.
The following is displayed on the screen:
Category mode de-selected
Channel selection continues in the same way as before.
Volume, Balance and Tone Settings
•
Press one of these
buttons and the menu for setting the volume, bal-
ance, tone controls (highs and lows), stereo-width and pseudo-stereo is dis-
played..
>Volume:
21
IIIIIIIIIIIIIIIIIIIIIIIIIII...................
Balance:
00
.................................II..........................
Highs:
00
.................................II..........................
Lows:
00
.................................II..........................
Stereo-width:
00
.................................II..........................
Pseudo-stereo:
OFF
Use these
buttons or the
button to select the required menu option
and use this
to make changes.
These settings have no control over the VCR scart socket, ensuring that the re-
cording is not disturbed.
Important
The option "Stereo-width" enables you to set the width of your choice.
"Pseudo-stereo" simulates stereo, and is only valid for and therefore only select-
able with mono reception. "Pseudo-stereo" mode can be simulated, by switching a
stereo program over to mono.
The OSD window will be cleared after 3 seconds.