Kathrein UFD 346 - Manual (Page 16)

Selecting TV Programs
16
Selecting TV Programs
The satellite receiver has already been pre-programmed by the manufacturer as a
satellite reception system with a feeder system working with a 9.75 GHz oscillator
frequency. All selected programs are shown in the accompanying table.
If you are going to use your satellite reception system with a feeder system that
uses a different frequency, you must set the receiver to the oscillator frequency
during the installation.
This is explained in the section ”Basic Setting-up, Oscillator Frequency”.
Setting-up TV Programs
When selecting new TV programs, the corresponding video and audio receiving
parameters must be set-up.
The up-to-date program allocation details can be obtained from satellite program
magazines or from SAT 1 videotext, starting at page 516.
•
First select the channel number where you wish to save the new program.
•
Call up the video-menu, by pressing these + buttons consecutively.
or
•
Call up the audio-menu, by pressing these + buttons consecutively.
•
Switch between video and audio menus by pressing either of these
buttons.
•
Select the required menu line by pressing these buttons.
•
The numbers may be entered directly by pressing these
buttons.
or
•
You may step through the values by using these buttons.
•
Press this button twice, to save your settings.
•
Exit the menu by pressing this button.
Important You may leave any setting-up mode at any time (without saving) and return to the
normal mode by pressing this
button
The ”Video” Menu
The following settings may be made within the video menu:
Channel: P002
Program name: ZDF
Sat-frequency: 10964 MHz
Polarity: Hor. Low
Orbital position: 1
Hub: 16 MHz
Oscillator: LO 1
Decoder menu...
0-9 VOL VID AUD A/B STBY STOR
The status line at the bottom of the menu displays the buttons that you must use to
change the settings.