Kenwood DPC-X937 - Manual (Page 37)

37
DEUTSCH
IT
ALIANO
ESP
AÑOL
3
Press the 4 key or 3/¢ key.
Setting continuous playback (only by remote control operation)
When the disc is removed from the unit, playback of music can be continued using the data stored in the memory.
This allows you to enjoy music even during replacement of the disc. Press during stop status.
1
Press and held the MENU key for more than
2 seconds.
2
Press the MENU key once. The mode changes each time the 4 or 3/¢ key is
pressed.
1 "CP on" : Continuous playback is activated
2 "CP OFF" : Cancel
÷ Continuous playback can be activated only when the SHOCK GUARD function is set to "S.G. HI". (DPC-X937 only)
÷ Continuous playback function cannot be used when the digital output jack of the unit is connected to another
audio component. (DPC-X937 only)
When the continuous playback is set to "CP on" :
÷ Even when you press the 7 key to open the top cover and change the disc, the current playback continues without
interruption. (Pressing the 7 key one more time while the top cover is open stops the continued playback.)
Playback can be continued till the top cover is closed and the 3/¢ is pressed. The continuous playback time is
variable depending on the amount of music data stored in memory, etc.
÷ To switch the power off, press the 7 key three times if the unit is presently in play mode or press the 7 key twice
if the unit is in stop mode.
4
Press the MENU key.
*5378_25_38EN 03.7.3, 4:34 PM 37