Kenwood DPC-X937 - Manual (Page 42)

42
DEUTSCH
IT
ALIANO
ESP
AÑOL
Symptom Cause Remedy
÷ The headphone plug is dirty.
÷ The batteries are low.
÷ The headphones are connected incompletely.
÷ A source of strong magnetism or radio wave, such
as a TV set or cellular phone, is present near the unit.
÷ Commercially available rechargeable batteries are
used.
÷ The power of the unit is on.
÷ The main unit is placed incorrectly on the re-
charger stand. (DPC-X937/DPC-X637 only)
÷ Continuous playback is set to "CP on".
÷ The SHOCK GUARD function is engaged.
Noise interferes.
Rechargeable batteries
cannot be recharged.
Playback will not stop.
The disc rotation stops
in the middle of
playback.
÷ Clean it.
÷ Replace or recharge the batteries.
÷ Insert the plug securely into the (Head-
phones/ Remote control unit) jack.
÷ Install the unit away from a TV set, cellular phone,
etc.
÷ Use the exclusive rechargeable batteries (NB-
3A70).
÷ Turn the power off.
÷ Place the main unit correctly.
÷ Set continuous playback to "CP OFF". (Page 37)
÷ This is normal and not a problem.
Message Meaning Action
÷ Insert a CD into the unit. ÷ There is no CD in the unit.
Meaning of display messages
"nodISC"
Note :
1. This system uses a microcomputer so it may malfunction due to external noise or interference. In such a case, unplug the power cord and
remove the batteries, then re-connect the power cord and insert the batteries again.
2. Erroneous operation may occur when the headphone plug is plugged or unplugged; but this is not a malfunction.
*5378_39_42EN 03.7.3, 2:19 PM 42