KORG TRITON Extreme music workstation/sampler - Manual (Page 115)

111
If you want to route the sound through an insert effect
and then into Valve Force, set the post-IFX “BUS Sel.”
to 3/4(Tube), 3(Tube), or 4(Tube).
Use “BUS Sel.” to assign the output of Valve Force.
You can send the output to the L/R bus, the insert
effect IFX1–IFX5 bus, or the 1, 2 buses.
5 If you want to sample the sound that has passed
through Valve Force, set “Source BUS” to the final
output bus of the Valve Force signal.
You can sample the signal if you’ve set “Placement” to
Insert (Use 3/4 BUS).
Adjusting the Valve Force settings, and sam-
pling
6 Adjust the Valve Force settings, and sample the
result.
For the sampling procedure, refer to QS p.21.
Resampling the output of Valve Force
If you want to send a multisample through Valve Force
and resample the result, refer to the example of applying
an insert effect (
☞p.70).
In step 6 ( ☞p.70), set “BUS (IFX) Select” to 3(Tube),
4(Tube), or 3/4(Tube), and then resample.
Valve Force settings for AUDIO INPUT
In Program, Combination, Sequencer, Song Play, and
Media modes, you can send an external audio input from
the AUDIO INPUT 1, 2, or S/P DIF IN jacks through
Valve Force and output the result.
This is specified by the “Input (COMBI, PROG, SEQ,
S.PLAY, MEDIA)”; the setting is common to each of these
modes (
☞p.107, step 1).
As an example here, we will explain the settings for Pro-
gram mode.
1 Press the VALVE FORCE [ON/OFF] key to turn Valve
Force on. (The key will light.)
Placement
2 Access the Program P9: Master Effect, VALVE page.
3 Use “Placement” to specify the placement of the
Valve Force circuit. ( ☞p.109, step 3)
In/Out
You can’t use Valve Force on the L/R output from S/
P DIF, nor when resampling the L/R output in the
various modes.
4 Specify the input/output destination for the Valve
Force circuit.
If “Placement” = Final:
The external audio source input to the L/R bus will be
sent through Valve Force at the final stage of the L/R
output.
Set “BUS (IFX/Indiv.) Select” to L/R or IFX1–IFX5. If
you use IFX1–IFX5, set the post-IFX “BUS Sel.” (inset
FX page) to L/R.
Program
Combination
Sequencer
Sampling
Song Play
Global
Ef
fect
Media, etc
Preset
Other