KORG TRITON Extreme music workstation/sampler - Manual (Page 29)

25
3 Adjust the “Lvl” (Level) for High and Low multisam-
ples to set their volume balance.
If you do not wish to use this function, set the “Veloc-
ity M.Sample SW Lo
→ Hi” value to 001. Only the
High multisample will sound.
Rev (Reverse) check box
If this is checked, the multisample will be played back-
ward. This can produce interesting results when used on
sound-effects, etc. Normally you will not check this.
● When “Oscillator Mode” = Double
To use OSC2, set “Oscillator Mode” to Double in the Pro-
gram Basic page.
In the same way as for OSC1, you can set High and Low
multisamples for OSC2.
The playback pitch can be set independently. By using the
same multisample with slightly different “Tune” settings,
you can “detune” the oscillators to produce a richer
sound.
It will be convenient to use the page menu command
“Copy Oscillator” to make the oscillator settings
match each other.
● When “Oscillator Mode” = Drums
In the Program Basic page, set “Oscillator Mode” to
Drums
. When this is set to Drums, you will be able to cre-
ate a drum program.
This will select a drum kit instead of a multisample. TRI-
TON Extreme provides 50 factory preset drum kits that
are suitable for a wide variety of music. (
☞VNL)
Here you can only select a drum kit. To edit or create a
drum kit, use Global P5: Drum Kit (
☞p.92).
The following multisamples or drum kits can be used
for the oscillator.
• Preset multisamples (see the table on the preceding
page)
• Multisamples that you sampled (RAM)
(Programs can be created from multisamples/samples
that you sampled in Sampling mode etc. or loaded
from media in Media mode.)
• Nine internal drum kits (ROM)
• 144 user drum kits created in Global mode
(Drum samples can be freely assigned to each key to
create a drum kit. For the sound of each key, you can
make filter and amp settings, and specify routing to the
effects and to the individual audio outputs.)
Velocity Zone page
Here you can specify the range of velocities for each oscil-
lator. In the example shown above, the velocity ranges are
as follows.
• OSC1 will sound at all velocity values.
• OSC2 will sound only on strongly played notes (64
and above).
• You can use Velocity Multisample Switching in
addition to this parameter ( ☞“High Multisample, Low
Multisample”). For this example, set “OSC1” in
“Velocity M.Sample SW Lo
→Hi” to 032 and “OSC2”
to 096. The settings are shown as vertical lines in the
velocity zone display.
In this example, the multisamples will sound over four
levels.
Controller Setup page
For each program, this tab lets you make settings for the
[SW1] and [SW2] key, and for the B-mode of REALTIME
CONTROLS knobs [1]–[4] (
☞p.129, PG p.14, 279, 280)
Velocity values 001–031: sounds only the OSC1 Low
multisample.
Velocity values 032–063: sounds only the OSC1 High
multisample.
Velocity values 064–095: sounds the OSC1 High multi-
sample and the OSC2 Low
multisample.
Velocity values 096–127: sounds the OSC1 High multi-
sample and the OSC2 High
multisample.
Program
Combination
Sequencer
Sampling
Song Play
Global
Ef
fect
Media, etc
Preset
Other