KORG TRITON Extreme music workstation/sampler - Manual (Page 95)

91
pitch change speed, volume, the pan following an insert
effect, pan, volume, or send levels to the master effects
(
☞PG p.282).
You can use this as a source for alternate modulation
or effect dynamic modulation, and use it to control
program parameters or effect parameters. In this case,
set “Foot Switch Assign” to Foot SW (CC#82), and
“Foot Pedal Assign” to Foot Pedal (CC#04).
Here we will show how to make settings that allow an
assignable switch to change programs or combinations.
1 Press the “Foot Switch Assign” popup button, and
press either Program Up or Program Down.
Program Up
will cause the next higher program num-
ber to be selected each time you press the foot switch.
Program Down
will cause the next lower program
number to be selected each time you press the foot
switch.
2 Set the “Foot Switch Polarity” to the polarity of the
foot switch you have connected.
If you have connected a Korg PS-1 pedal switch, set
this to (–) KORG Standard. If the polarity is not set
correctly, the pedal will not function appropriately.
3 Either press the [PROG] key to enter Program P0:
Play, or press the [COMBI] key to enter Combination
P0: Play. When you press the foot switch, the pro-
gram/combination will change.
Creating original scales
P3: User Scale
Creating a scale and assigning it to a
program etc.
You can create your own original scales. You can create
sixteen different User Octave Scales in which the pitch of
each note of the octave is repeated for all octaves, and one
User All Note Scale
in which the pitch of each of the 128
notes can be specified independently.
By adjusting the pitch of each key in the range of ±99, you
can raise or lower it by as much as approximately one
semitone relative to the normal pitch.
The user scales you create here can be used by specifying
the scale for a program, for each timbre of a combination,
or for each track of a song (Sequencer/Song Play).
These settings are made by the Scale “Use Prog’s Scale”
parameters in the following pages.
Here is how to set the scale type for each timbre in
Sequencer mode.
1 Create a user octave scale or a user all notes scale.
Select a key, and use the VALUE controller to adjust the
pitch. The range of ±99 raises or lowers the pitch
approximately one semitone above or below the stan-
dard pitch.
You can also select a key by holding down the
[ENTER] key and playing the desired note on the
keyboard.
You can copy one of the preset scales and edit it to
create an original scale. Execute the page menu com-
mand “Copy Scale.”
2 Press the [SEQ] key to enter Sequencer mode.
3 After pressing the [MENU] key, press the P2: Trk
Param.
4 Press the Other 1–8 tab or Other 9–16 tab to select the
Sequencer P2: Trk Param, Other page.
5 If you wish the program assigned to a track to use the
scale saved with that individual program check the
“Use Program’s Scale” check box for that track.
Tracks that are not checked will use the scale specified
by Scale “Type (Song’s Scale).”
6 Set “Type (Song’s Scale)” to select the scale for the
currently selected song.
Program mode Program P1: Edit-Basic, Program Basic
Combination mode Combination P2: Edit-Trk Param, Other
Sequencer mode Sequencer P2: Trk Param, Other
Song Play mode Song Play P1: Track, Status/Scale
Program
Combination
Sequencer
Sampling
Song Play
Global
Ef
fect
Media, etc
Preset
Other