Kathrein UFD 345 - Manual (Page 10)

Receiver operation
10
Bedienung des Receivers
In this chapter you learn how to select TV and radio programmes using your re-
ceiver, and how to adjust the volume and set up other functions.
Switching the unit on
•
Once the supply voltage is connected the unit goes into standby mode.
•
The key on the remote control is used to switch between standby and
normal operation. Operation is shown by means of a red LED indicator in the
infrared sensor.
•
The last programme slot selected is tuned in (last-status memory).
Switching between TV and radio mode
Your receiver allows you to receive TV programmes or radio programmes.
After switching on, the receiver is in either the TV mode or the radio mode (de-
pending on the mode when switched off).).
In TV mode, the programme slot indicator in the on-screen display (OSD) begins
with "P". In radio mode, the screen is blanked out and the on-screen display begins
with "R..“.
•
Press the key on the remote control handset to switch between TV- and
radio mode.
Note In the initial setup menu, a continuous on-screen display of the radio programme
slot can be selected independent of the TV setting (see section: “Initial settings, On
Screen Displays “).
Selecting a programme
•
Use the numeric keys ... to select the desired programme directly.
Example for a three-digit entry (with setting “free programme selection”):
Selection of programme slot 147
•
1 is entered, programme slot 1 appears
•
4 is entered, programme slot 14 appears
•
7 is entered, programme slot 147 now appears.
or
•
Use the keys to step through the programmes in succession.
After the programme changeover, the programme slot and programme name are
superimposed on the screen for approximately three seconds.