Kathrein UFD 345 - Manual (Page 20)

Initial settings
20
can be invoked only from the switched-off state. (power supply interrupted).
Calling the initial setup menu
•
Withdraw the mains supply plug (inner hollow conductor plug) from the socket
(6).
•
Press both the programme selection buttons (4) on the infrared sensor
and keep them pressed.
•
Insert the unit‘s mains supply plug again.
•
When the following screen menu appears release the keys .
The initial setup menu is displayed.
>OSD language: ENGLISH
LNB supply: ON
-in standby: OFF
Programme selection: FREE
OSD: OFF
Oscillator menu...
DiSEqC menu ...
VOL 0-9 A/B STOR STBY
The bottom line shows the keys you can use to make the settings.
Settings are made in the initial setup menu in the same manner as in the other
menus for the station programming:
•
Select menu entries with the keys.
•
Carry out settings and call up submenus with the keys
(and use numeric keys 0-9 on inputting frequency).
•
Press the key twice to save your settings.
•
Return with the key.