Kathrein UFD 345 - Manual (Page 15)

Programming TV programmes
15
Programmieren von TV-Programmen
The satellite receiver has already been factory pre-programmed for satellite re-
ceiving systems with feed systems (receiving system) which have an oscillator fre-
quency of 9.75 GHz. All of the programmes set up are listed in the table enclosed.
If your satellite receiving system uses a feed system with a different oscillator fre-
quency, the receiver only needs to be matched to the feed system oscillator fre-
quency during the installation.
The procedure for this can be found in section: “Initial settings, Oscillator fre-
quency“.
Tuning in TV programmes
To tune in to new TV programmes, the video and audio reception parameters need
to be set up accordingly.
The latest programme assignments can be obtained from satellite programme
magazines, or called up via the videotext of programme Sat 1 from page 516.
•
First select the programme slot that you want to programme afresh.
•
Call up the video menu by pressing the + keys in succession.
or
•
Call up the audio menu: press keys + in succession.
•
Switch between video and audio menus using
the key or the key.
•
Select the desired menu line using the keys .
•
For direct numeric input use the keys … .
or
•
Alter the values step-by-step using the keys.
•
Press the key twice in order to save your settings.
•
Exit from the menu with the key.
Note You can terminate any setup procedure immediately (also without saving settings)
by returning to normal operation with the
key.
The “Video” menu
The following settings can be made in the video menu:
Programme slot: P002
Programme name: ZDF
Sat-Frequency: 10964 MHz
Polarisation: Hor. Low
Orbit Position: 1
Deviation: 16 MHz
Oscillator: LO 1
Decoder menu...
STOR
VOL 0-9 VID AUD A/B STBY
The bottom line shows the keys you can use to make the settings.