Keating Of Chicago Safe and Easy Filter - Manual (Page 6)

– 4 –
Do’s
1. Read and follow the filtering procedure.
2. Always verify 2 connections are engaged
when filtering.
•
Quick disconnect under the tub to the
motor housing.
• Quick disconnect on top of the motor
housing to the fryer or central filter quick
disconnect.
3. Stir the oil completely before draining.
4. Place the sump screen under the filter paper.
5. Change the filter paper for each fryer filtered.
Don’ts
1. Run water through the pump.
2. Filter oil without wearing the proper attire.
3. Filter cold oil (must be between 250°- 350°).
4. Use the 6 foot hose to clean the fry tank (hose
should only be used to discard the oil).
5. Powerwash, spray, or hose down the motor
housing area, as electrical components are
present.
Quick Hits
4. Push the small black knob on the filter panel to the left
(“Oil to Hose”).
5. Place the nozzle of the hose in an approved discard
container.
6. Drain the oil.
7. Plug the filter into the receptacle.
8. Turn the motor switch ON (the green light will illuminate).
CAUTION
A KEATING FRYER OR FILTER SHOULD BE DRAINED
ONLY UNDER THE SUPERVISION OF PROPERLY
TRAINED PERSONNEL. WHEN DISCARDING OIL, A
COVERED RECEPTACLE APPROVED FOR USE WITH
HOT OIL SHOULD BE USED. USE OF A NON-APPROVED
RECEPTACLE OR METHOD OF DRAINING THE OIL
COULD JEOPARDIZE THE SAFETY OF THE OPERATOR.
NOTE: Keep the pump turned “ON” until bubbles occur
in the discard receptacle. Allow the pump to run an
additional 15 seconds to clear all pipes.
9. Turn the motor switch “OFF”.
10. Push the small black knob on the filter panel to the
right (“Oil to Fryer”).
11. Close drain valve of the fryer (large black knob).
12. Hose can be removed by pulling the handle on the left
of the motor housing.
13. Prepare filter tub for next useage (see section A).
14. Clean excess oil from wand and quick disconnect on the
hose.
CAUTION
To avoid damaging the fryer, do not power wash, spray
or hose it down while cleaning it.
Pump must be primed with oil after boil-out with water.
Failure to lubricate pump may cause severe damage to Filter
System and void the warranty.
Connect hose here to discard oil
FIGURE 8.
CAUTION
HOT FLUID. DO NOT FILL BEYOND
MAXIMUM FILL LINE LOCATED IN
THE FRYER VESSEL.