Kathrein UFD 400 - Manual (Page 11)

Receiver operation
11
Note With the setting “2- or 3-digit programme selection“ there is a switch to the desired
programme after approximately 3 seconds. Digits can be entered during this time.
With the setting “free entry“ (in the above example) the receiver switches to the
corresponding programme slot immediately after each input.
In the initial setup menu, a continuous on-screen display of the programme slot can
be selected (see section: “Initial settings, On Screen Displays“).
Adjusting volume, balance and tone
•
Use the keys to adjust the volume to the desired level.
The volume is adjustable in 21 steps. The volume level set appears on the LED
display for approximately 3 seconds. At the same time a bar indicator appears on
the screen.
Note The settings are not operative on the VCR Scart socket in order not to disturb any
recordings.
The on-screen display is removed again after approximately 3 seconds.
Whilst the menu for volume adjustment is overlaid, the
key can be used to acti-
vate the following menu for balance adjustment, tone adjustment, stereo width and
pseudo-stereo.
Using the keys or the key you can select the particular menu entry and
then make changes with the keys.
Note In the menu entry “Stereo Width" the stereo base width can be adjusted independ-
ently.
“Pseudo-Stereo" can be used to simulate a “stereo-like“ effect with mono pro-
grammes, and should thus only be activated with mono reception.
If Pseudo-Stereo has been turned “On“, the stereo width can no longer be altered.
Muting the sound
•
Press the key.
The sound is muted, allowing you to make a phone call undisturbed, for example.
In the LED display the sound muting is shown by means of 3 dots.
•
Press the key again to turn the sound back on.
Note Mute is not operative at the VCR Scart socket.