Kathrein UFD 400 - Manual (Page 19)

Programming TV programmes
19
Orbit Position
In the “Orbit Position“ menu entry, division of the satellites into orbit positions 1 to 4
is carried out.
This dividing up is necessary for the signal selection with the 22 kHz, tone-burst or
DiSEqC switching signal on reception from two (or more) satellites.
The receiver is pre-programmed in accordance with the following table.
Satellite Orbit position Switching signal 22 kHz
Astra 19.2° east 1 Off
Eutelsat 13° east 2 On
Eutelsat 10° east 3 Off
Eutelsat 16° east 4 On
In the pre-programming, position 1 was likewise assigned to all of the other satel-
lites.
Note In the initial setup menu (DiSEqC menu, menu entry 22 kHz) the particular setting
is specified (frequency band
High/Low or orbit position Pos A/B) for which
the 22 kHz switching signal is operative.
Default setting in initial setup menu:
22 kHz signal on for “
Pos. A/B“.
Video deviation
The satellites transmit their signals with different video deviation, 16 or
25 MHz. The setting has an effect on the picture brightness.
•
Adjust the video deviation to obtain optimum picture brightness.
Decoder menu
You can attach a decoder to the decoder Scart socket for a Pay-TV programme
with video signal.
The receiver recognises Pay-TV programmes for which decoders supply a switch-
ing signal (e.g. like Premiere) independently, and switches this signal through to
the TV- and VCR Scart socket.
For decoders that do not supply a switching voltage the following setting is to be
carried out.
•
Call up the video setup menu
•
Select menu entry “Decoder menu“
•
Activate the “Decoder menu“.
Setting option:
Internal / External
Internal / External
•
Set the video signal path to external,
•
Set the audio signal path to external only if audio signal is encoded as well.
•
Save the settings with the key.