Kyocera G2GO - Manual (Page 9)

User Guide 9
1 Get Started
Phone Battery
Install the Battery
1. With the back of the
phone facing you, press
on the back cover and
slide it to the bottom of
the phone.
2. Lift the back cover from
the bottom to remove.
3. Place the battery in the
phone casing with the
metal contacts toward
the top of the phone.
4. Align the back cover
side tabs with the slots
on each side of the
phone.
5. Slide the back cover to
the top of the phone
until it is securely in
place.
Note: Before removing the
battery, make sure to power
off the phone.
Charge the Battery
You must have at least a partial charge in the
battery to make or receive calls.
To charge the battery:
1. Remove the rubber
USB cover and connect
the AC adapter to the
microUSB jack on the
side of the phone.
2. Plug the adapter into a
wall outlet.
The battery icon in the upper-right corner of the
screen shows whether the phone is:
– Charging (animated icon)
– Partially charged
– Fully charged
You can safely recharge the battery at any time,
even if it has a partial charge.
Warning: The battery does not charge if you
use the phone while it is connected to an AC
adapter.