Kyocera VMKX5C - Manual (Page 9)

User Guide for the Slider Sonic Phone 1
1 G
ETTING
S
TARTED
Installing the battery
Your Slider Sonic phone comes with a removable
lithium ion (LI Ion) battery.
Fully charge the
battery before using the phone.
To install the battery:
1. Hold the phone face
down.
2. Slide the tab at the
bottom of the door up
and remove the battery
door.
3. Place the battery in the
phone casing with the
metal contacts facing
the right side of the
phone.
4. Replace the battery
door by sliding the notches into the openings
near the top of the phone.
5. Lower the battery door
and slide the tab at the
bottom of the door up
and then down to
secure the cover into
place.
Charging the battery
You must have at least a partial charge in the
battery to make or receive calls.
To charge the battery:
1. Connect the AC adapter to the jack on the
bottom of the phone.
2. Plug the adapter into a
wall outlet.
The battery icon in the
upper-right corner of the
screen tells you whether the
phone is:
• Charging (the icon is
animated)
• Partially charged
• Fully charged
Note: The battery will not charge if you use the
phone while it is connected to an AC adapter.
Recharging the battery
You can safely recharge the battery at any time,
even if it has a partial charge.
Note: To remove the battery, make sure the phone
is powered off.