Kodak I7300 - Manual (Page 94)

A-61133 March 2003 4-23
Setting up non-ANSI/AIIM
image marks If the film you are retrieving images from has image marks that do not
meet the ANSI standards because the film was created by a non-
Kodak microfilmer, use the Other… option on the Image Marks tab to
define the image mark size.
1. Select Other.
2. Click Setup to display the Image Marks dialog box. Use this dialog
box to adjust the minimum and maximum values for each image
mark size.
3. You can enter the value in the text field or use the arrows to scroll to
the desired value for each image mark size.
•
Small Minimum Size

specifies the minimum size of image
marks that will be interpreted as “small” by the scanner. Select a
value from 1 to 96.
•
Medium Minimum Size

specifies the minimum size of image
marks that will be interpreted as “medium” by the scanner.
Select a value from 2 to 97.
•
Large Minimum Size

specifies the minimum size of image
marks that will be interpreted as “large” by the scanner. Select a
value from 3 to 98.
•
Large Maximum Size

specifies the maximum size of image
marks that will be interpreted as “large” by the scanner. Select a
value from 4 to 99.
4. Click OK to save image mark size values.