Klipsch DVD Audio/Video System CS-700 - Manual (Page 17)

MUTE Reduces the audio to a minimum level. Press again to restore the volume.
OPEN/CLOSE Opens and closes the disc drawer.
POwEr Turns the Klipsch controller on and off and tunes it to the last selected input.
If the remote is programmed to operate other components, the POwER
button is used together with the component buttons ( AUX 1, TV, AUX 2,
and SAT/CAB ) to turn the components on and off.
PLAY Begins playback of disc (or video tape if the remote is properly programmed
to operate a VCR).
PAUSE Temporarily stops disc play (or video recording/playback, recordable DVD
or compatible camcorder, if the remote is properly programmed to operate
those types of components).
rECOrD When the remote is properly programmed, records a program on a
recordable component, such as VCR, DVR, or RDV.
rEVErSE Searches backward through a DVD, CD, mp3, and radio stations during
playback (or video tape, recordable DVD, or camcorder if the remote is
properly programmed).
SAT/CAB Switches the Klipsch unit to SAT/CAB INPUTS. When the SAT/CAB button
is programmed, it operates the basic functions of the component connected
to the SAT/CABLE/HD INPUT jacks.
STOP Stops playback.
SUrrOUND Toggles between the OFF, ON or WIDE options in surround audio.
TV Selects the TV for which the button was programmed and operates the
basic functions of that TV.
VOLUME Controls the audio level in every mode except when using the menu system.
Also, restores volume when MUTE has been activated.
Programming Your Remote Control
Your remote control is a universal remote which means you can program it to operate other brands of
electronic components, such as TVs, satellite receivers, cable boxes, VCRs, etc. Follow these steps to
program your remote control.
T urn off the component to be programmed.
Look up the brand and code in the code list (located in the “More Information” section of this
manual) or the “
Remote Control” section of the on-screen menu system.
Press and hold the component button ( AUX 1, AUX 2, TV or SAT/CAB) on the remote
control for three (3) seconds, or until the LED goes out.
Release the component button and enter the first code for your brand and type of component.
If the code is accepted, the LED will flash 3 times.
Press the
POwER button to see if the component turns on. If it doesn’t, try another code from
the list.
1.
2.
3.
4.
5.
6.
If the batteries are removed from the remote control
after you have programmed the component buttons,
you might need to reprogram the buttons. The remote
memory is only maintained for a short period of time.
Remote Control Batteries
ReMote ContRoL page 13/14
(SATELLITE RECEIVER/CABLE)
(VOLUME UP/DOwN)
MODE