Klipsch DVD Audio/Video System CS-700 - Manual (Page 8)

If your TV has an HDMI INPUT, connect the corresponding HDMI cable
(not supplied) from the HDMI OUTPUT of the Klipsch system to the
HDMI INPUT of the TV.
If you’re using COMPONENT jacks or HDMI and your TV supports
progressive scanning technology (see the TV owner’s manual if you
don’t know whether your TV is a progressive scan TV), slide the
P.SCAN switch on the back of your Klipsch system to the ON position.
If you put the P.SCAN switch in the ON position and your TV doesn’t
support progressive scan, you won’t see a picture on the TV screen.
4.
5.
If your TV doesn’t have HDMI or COMPONENT, but has S-VIDEO,
connect S-VIDEO cable (not supplied) to the Klipsch system’s
VIDEO
OUTPUT S-VIDEO jack and to the corresponding S-VIDEO jack on the TV.
If your TV has COMPONENT INPUT jacks (Y, P B , P R ) connect the (not
supplied) corresponding cables (either bundled or three separate
video grade cables—yellow) to the Klipsch system’s
VIDEO OUTPUT
COMPONENT Y, P B , P R jacks and to the corresponding input jacks on
the TV. To use this option, you must also connect the corresponding Y,
P
B , P R OUTPUT to your TV.
If your TV doesn’t have COMPONENT or S-VIDEO, connect the TV’s
VIDEO INPUT (yellow) to the Klipsch system’s COMPOSITE jack (yellow)
with the supplied cable.
1.
2.
3.
COMPOSITE
INPUT 1
L
R
S-VIDEO
V
INPUT 2
L
R
V
INPUT 3
P B
Y
P R
INPUT 4
P B
Y
P R
COMPONENT
OUTPUT
P B
Y
P R
COMPONENT AUDIO / VIDEO
OUTPUT
L
R
V
DIGITAL OPTICAL
OUTPUT
DIGITAL COAXIAL
OUTPUT
ANTENNA B
INPUT
ANTENNA A
INPUT
TV BACK PANEL
HDMI
INPUT
- OR -
OR
2
1
5
3
KLIPSCH CONTROLLER
4
OR
STeP 4: Connect Klipsch System to the TV's Input
Note: until recently, tVs only had VIDeo INPut jacks. therefore, your tV
might not carry the "IN" or "Input" label even though it is an input.
Note: If an HDMI (digital) input is used to connect a source (such as a
cable or satellite box) to the CS-700, the tV must also be connected with
an HDMI cable to preserve the digital signal. Also, if an analog signal is
connected to the CS-700, the tV must also be connected with an analog
signal. the CS-700 will not up-convert an analog signal to a digital signal.
Please see appendix I (page 28) for the basics on how input
and output jacks work with your Klipsch system.
Input and Output Jacks