Kenwood KRF-V5200D - Manual (Page 19)

English
19
Distance setting ("DISTANCE")
This sets the distance from each speaker to the listening position.
œ Measure the distance from the listening position to
each speaker and jot down in the table below.
Speaker Indicator
Distance from the listening
position
Front speaker (left) "L" feet (meters)
Center speaker "C" feet (meters)
Front speaker (right) "R" feet (meters)
Surround speaker (right) "RS" feet (meters)
Surround speaker (left) "LS" feet (meters)
Subwoofer "SW" feet (meters)
∑ See <Getting into the setup mode> (&) and
select "DISTANCE".
é Use [MULTI CONTROL 5/∞] to select the distance
to the front speaker.
• Adjustment will start from front left speaker.
Indicator
® Press [SETUP].
† Repeat steps é – ® to input the distance for the
rest of the speaker.
¥ Go to the next setting, "LFE LVL".
• If you wish to exit the setup mode, see <To exit the setup mode>
&.
Low frequency effects level ("LFE
LVL")
Low frequency effect signal is used exclusively for giving the field
effect of bass tone in the Dolby Digital and DTS signal.
œ See <Getting into the setup mode> (&) and
select "LFE LVL".
∑ Use [MULTI CONTROL 5/∞] to adjust the low
frequency effect level.
• The level is adjusted from 0dB to -10dB in 1dB step decrements.
é Press [SETUP].
• The setup is complete when the "EXIT" indication appears.
® Press [SETUP] to exit the setup mode.