Kenwood KRF-V5200D - Manual (Page 32)

32
English
Fine adjustment of the sound
You can make further adjustments to the sound while listening to
playback in the surround mode.
MULTI CONTROL
MULTI CONTROL
/O
SOUND
SPEAKERS ON/OFF
œ Press [SOUND] until the desired item appears on
the display.
Each time you press the key, the menu changes as
follows. Note that some items are not displayed
depending on speaker settings and listen mode.
Display Adjustment Range
"C" Center speaker level * 1 -10 – +10dB
"RS" Surround right speaker level * 1 -10 – +10dB
"LS" Surround left speaker level * 1 -10 – +10dB
"SW" Subwoofer level * 1 -10 – +10dB
"INPUT" Input level * 2 -6, -3, 0
"NIGHT" Midnight mode * 3 "ON", "OFF"
"PANORAMA" Panorama mode * 4 "ON", "OFF"
"DIMENSION" Dimension * 4
"CENTER WIDTH" Center width * 4
Input source name Exit the adjustment mode.
* 1 The adjustment is only temporary for the current input selection.
The value will return automatically to the original setup value
when the power is turned on/off or when the input selection is
changed.
* 2 Analog mode only
* 3 Dolby Digital and DTS mode only
* 4 Pro Logic II Music mode only.
∑ Use the [MULTI CONTROL 5/∞] to adjust the
setting as desired.
Speaker level adjustment Speaker level adjustment
The output level from the desired speaker channels can be fine
adjusted according to the properties of each disc.
The adjustment is only temporary for the current input selection.
The value will return automatically to the original setup value
when the power is turned on/off or when the input selection is
changed.
œ Press [SOUND] repeatedly until the speaker to be
adjusted appears on the display. ("C", "RS", "LS", or
"SW")
∑ Use the [MULTI CONTROL 5/∞] to adjust the level.
Input level adjustment (analog sources Input level adjustment (analog sources
only)
only)
If the input level of an analog source signal is too high, the CLIP
indicator will blink to indicate. Adjust the input level.
œ Press [SOUND] repeatedly until "INPUT" appears
on the display.
∑ Use the [MULTI CONTROL 5/∞] to adjust the level.
Midnight mode (Dolby Digital and DTS Midnight mode (Dolby Digital and DTS
mode only)
mode only)
When watching movies at night, you might not be able to raise
the volume as loud as normal. Midnight mode compresses the
dynamic range of previously specified heavy sound passage of
the Dolby Digital and DTS mode sound track (like scenes with
sudden increases in volume) to minimize the difference in volume
between the scenes with heavy sound passage and scenes with
normal sound passage. This makes it easy to hear all of the sound
track, even when listening at low volumes.
œ Press [SOUND] repeatedly until "NIGHT" appears
on the display.
This can be selected only if "CD/DVD", "DVD/6CH" or
"VIDEO2" is selected as the source and the listen mode
is set to "DOLBY DIGITAL" or "DTS".
∑ Use [MULTI CONTROL 5/∞] to select the "ON" or
"OFF" setting.
• Some Dolby Digital or DTS software may not be compatible with
the Midnight mode.
Further adjustments