Kenwood DNX6980 - Manual (Page 89)

88 88
Return to the Top page
Audio Setting Up
NOTE
• When the rear speaker sound is switched, the
audio source that is output at the AV OUTPUT
terminal is also switched to the same source.
• When the dual zone function is set to on, the
following functions are not available.
• Output from the subwoofer
• Subwoofer Level/Bass Boost
(P.85)
• Equalizer Control/Space Enhancer /
Listening Position (P.85, 88, 88)
• DSP Bypass Control /Speaker Setup/Car
Type (DTA) Setup (P.84, 81, 83)
Space Enhancer
1
Touch [Space Enhancer].
Space Enhancer screen appears.
2
Touch [Small], [Large], or [OFF].
Each setting value indicates the
soundscape level.
NOTE
• This setting is not available during tuner source.
Listening Position
You can adjust the sound effects according
to your listening position.
1
Touch [Position].
Position screen appears.
2
Select listening position from
[Front R] (Right front), [Front L] (Left
front), [Front All] (All front), [All], and
[User] using [
2] and [3].
NOTE
• You can store present setting in memory by
touching [P1], [P2], or [P3] for 2 seconds. You can
also recall the setting by touching corresponding
number.
• The final distance is adjusted to the total of car
type set up value (P.83) and position setup (both
position and position DTA) value.
• If you change the car type set up value (P.83) , the
position is set to [All].
• Only the adjusted distance of position setup
(position and position DTA values) is stored in
memory. Therefore, the final adjustment distance
changes if you change the car type set up value
(P.83) .