Kenwood TH-G71E - Manual (Page 9)

3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
INSTALLING ALKALINE BATTERIES
WARNING!
◆ DO NOT INSTALL THE BATTERIES IN A HAZARDOUS
ENVIRONMENT WHERE SPARKS COULD CAUSE AN
EXPLOSION.
◆ NEVER DISCARD OLD BATTERIES IN FIRE BECAUSE
EXTREMELY HIGH TEMPERATURES CAN CAUSE BATTERIES
TO EXPLODE.
Note:
◆ It is recommended to use high quality alkaline batteries rather than
manganese batteries to enjoy longer periods of battery life. Do not
use commercially available NiCd batteries.
◆ If you will not use the transceiver for a long period, remove the
batteries from the battery case.
◆ Do not use different quality of batteries together.
◆ When the battery voltage is low, replace all four old batteries with
new ones.
1 To open the battery case cover, push on the locking
tab, then pull the cover.
2 Insert (or remove) four AA (LR6) alkaline batteries.
• Be sure to match the battery polarities with those
marked on the bottom of the battery case.
3 Align the two tabs on the battery case cover, then
close the cover until the locking tab clicks.
4 To install the battery case onto (or remove from) the
transceiver, follow steps 1 to 3 for INSTALLING THE
NiCd BATTERY PACK {page 2}.
Tab
Locking tab