Kyocera EN User Manual
Page 64
54
Sending or Receiving Data
Check with your service provider to see if both voice and data/fax signals
are supported. If the network cannot distinguish between voice and data/
fax calls, and you are expecting a data call, you can set the phone to data
mode.
Important—When the phone is in data mode, you cannot receive incoming
voice calls.
Setting up a data connection
Follow these steps to set up a CDMA data connection.
1.
With your phone turned off, plug the flat connector on one end of the
data cable into the port on the bottom of the phone.
2.
Plug the serial connector on the other end of the data cable into the serial
port on your computer.
3.
Turn on your computer.
4.
Press
or
to turn on the phone.
5.
Open a communications software package on your computer.
6.
To send or receive faxes and email or to access the Internet, follow the
directions that came with the communications software.
pwr