Kodak SCIENCE 1H9659 - Manual (Page 24)

Calibration Utility for MICROSOFT WINDOWS
1–16 September 1997 Part No. 1H9659
Using Normal Utility to Calibrate Your Printer
The Normal Utility calibration procedure allows you to create a new
calibration document or start from a calibration document that was
previously created and saved.
When you click on the Launch Normal Utility button in the Calibration
Utility selection box, the Normal Utility calibration procedure starts up
and the Calibration Utility window opens.
NOTE: If this is the first time that the Calibration Utility has been
run, or if there are no printers on the Select Printer drop-down
list, or if the Preferences files have been deleted, you must
select and open the export module for the printer that you
want to calibrate.
You can either create a new calibration table or open an existing one to
calibrate your printer.
D Information about creating a new calibration table is in “Creating a
New Calibration Document” on page 1–19.
D Information about using an existing calibration table is in “Opening an
Existing Calibration Table” on page 1–26.