Kyocera Tempo E2000 - Manual (Page 60)

52 Network
2. Say “Wake Up” again until you hear two
tones.
If the phone does not recognize your Wake Up
command, see
“Voice training” on page 52 .
Voice training
If you phone is having trouble recognizing your
voice, you can train by speaking number
commands.
1.
Select Menu > Settings > My Phone >
Voice Features > Voice Training .
2. Read the message and select OK .
3. Select Train Numbers .
4. Read the message and select OK .
5. Follow the prompts displayed on the screen.
Speak each number until training is
complete.
To untrain your phone select Select Menu >
Settings > My Phone > Voice Features > Voice
Training > OK > Untrain Numbers .
Phone information
You can access informtion regarding your phone.
Select
Menu > Settings > My Phone > Phone
Info and one of the following:
• Build Info shows specific software and
hardware information.
• Icon Key shows the icons used by your
phone.
Network
Data and Fax Calls
Your phone may be able to receive certain data or
faxes, depending on the system sending the
information. You cannot receive voice calls while
the phone is in data/fax mode.
To receive data or faxes, you must connect the
phone to a laptop or PC and switch the phone
from voice mode to data/fax mode.
Note: To purchase a cable, visit
www.kyocera-
wireless.com/store .
To enable data/fax mode, select Menu > Settings
> Network > Data/Fax Calls and of the
following:
•
Voice Only turns data/fax mode off.
• Fax, next call or Data, next call sets the
phone to data/fax mode for the next incoming
call or the next ten minutes.
• Fax, until off or Data, until off sets the
phone to data/fax mode until the phone is
turned off.
Privacy Alert
You set your phone to alert you when enhanced
digital CDMA privacy is lost or regained. Select
Menu > Settings > Network > Privacy Alert >
Enabled .