Knoll Systems HD102 - Manual (Page 10)

10
Press the top Keystone button to reduce the upper part of the image, and press the bottom Keystone
button to reduce the lower part.
Adjust the Contrast or Brightness in the Picture menu.
See page 21 for help with these menu adjustments.
Using the projector with Windows 98 for the first time
The first time you connect a computer running Windows 98 to the projector, the computer recognizes the
projector as “new hardware” and the Add New Hardware Wizard appears. Follow these instructions to use
the Wizard to load the correct driver (which was installed with your Windows operating system).
If you are running Windows 2000 or Windows ME, skip these steps and go to “Adjusting the image” on page
9.
a) Click Next to begin searching for the driver.
b) Make sure “Search for the best driver” is selected, then click Next.
c) Uncheck any checked boxes, and then click Next. Windows
automatically locates the driver. If this driver has been removed, reload
the driver using your Windows operating system CD.
d) When Windows finds the driver, you are ready to install it. Click Next.
Skip this section if you did not connect a USB mouse cable for Windows 98:
• If you connected the USB cable, the Add New Hardware Wizard appears again. Drivers must be
installed to use the USB functionality.
The Wizard launches three times:
• The first time it detects a USB Composite Device.
• The second time a USB Human Interface Device (for the keyboard).
• The third time it detects a USB Human Interface Device (for the mouse).
For Windows 2000, Windows ME, and Windows XP:
• The USB drivers are automatically installed.