Kodak 560 - Manual (Page 26)

Projector must be on a flat, stable surface.
The Xenon lamp is under pressure. Protect yourself from the
unlikely, but possible explosion of the lamp by wearing protective
glasses and clothing.
Do not open the lamp house cover during operation. Do not look
at the burning lamp directly. During lamp position adjustment,
employ a pair of good ultraviolet prevention eye glasses.
Do not apply stress or shock to the lamp even when the lamp is
not burning. Take extra care when shipping the projector with the
lamp inside.
Before removing the lamp house cover, be sure to unplug the
projector.
Ground the projector electrically for safety.
Before changing the lamp, read the safety precautions and observe
them.
Be careful not to connect the lamp to the wrong polarity. Supply
low ripple current for lamp.
Avoid projection in an extreme downward inclination. This may
cause your lamp to flicker.
Take care of cooling the lamp after usage.
Do not repeatedly perform the lamp on/off operation.
Do not disturb the air flow by placing any foreign matter in front of
the vent holes of the projector.
For lamps other than the ozone- free type, use effective room
ventilation.
Do not touch the lamp with naked fingers. When required, hold
the bulb with a piece of gauze or fabric to keep the bulb free from
finger prints. Hold lamp by the ends.
Operate the Xenon lamp under the rated maximum current.
Warning ∆∆∆∆∆
Safety Precautions
24