Kenwood KRF-V8030D - Manual (Page 16)

16
Operations
1
Listening to a source component
2
3
Start playback from the selected source.
1 "PHONO"
2 "TUNER"
3 "CD/DVD"
4 "TAPE" or "MD"
5 "VIDEO1"
6 "VIDEO2"
7 "VIDEO3"
8 "DVD/6ch"
9 "AV AUX"
The input sources change as shown below:
Selecting a source using the INPUT SELECTOR knob
Use the INPUT SELECTOR knob, MUSIC key, or MOVIE key
to select the source you want to listen to.
Use the VOLUME CONTROL (VOLUME +/–) to adjust the
volume.
MUSIC MOVIE
VOLUME+/–
INPUT SELECTOR
VOLUME CONTROL
Selecting a source using the MUSIC key
1 "CD/DVD"
2 "TAPE" or "MD"
3 "TUNER"
4 "PHONO"
1 "VIDEO1"
2 "VIDEO2"
3 "VIDEO3"
4 "DVD/6ch"
5 "AV AUX"
Selecting a source using the MOVIE key
Preparing for playback
Normal playback
Some preparatory steps are needed before starting playback.
Turning on the receiver
1 Turn on the power to the related components.
2 Turn on the power to this receiver by pressing POWER or
SYS.POWER
(and ON/STANDBY) key(s).
Selecting MD/TAPE
Select the source name corresponding to the component connected to
the MD/TAPE jacks. The initial factory setting is “
TAPE ”. To change the
source name associated with the MD/TAPE jacks to “ MD ,” follow the
steps below:
1 Use the INPUT SELECTOR knob to select “MD/TAPE”.
2 Hold down the AUTO key for more than 2 seconds.
• The source indication changes to “ MD ”.
• To return to the original indication, repeat the above procedure.
A ON : Sound from the speakers connected to the SPEAKERS A
terminals on the rear panel.
B ON : Sound from the speakers connected to the SPEAKERS B
terminals on the rear panel.
A+B ON : Sound from both the speakers connected to the SPEAK-
ERS A and B terminals on the rear panel.
A+B OFF : No sound from the speakers. Use this setting when listening
with headphones for stereo sound and virtual surround in all
playback modes.
Selecting the input mode
If you have selected a component connected to the CD, DVD, VIDEO2,
or VIDEO3 jacks, make sure that the input mode setting is correct for the
type of audio signal to be used. 9
AUTO
INPUT MODE
POWER
ON/STANDBY
INPUT SELECTOR
SPEAKERS A/B
LFE
C
S RS LS
TI.VOL
CLIP MUTE
RDS EON PTY
TP TA NEWS
L SP A R
SW
B
Selecting the speaker system
Press the SPEAKERS A or B key to select the speaker system to
be used.
The indicator for the speakers you
want to use should be lit.
• Activating a surround mode or selecting “DVD 6ch” as the input
source causes speaker system A to be selected automatically.
• When you use the PRE OUT jacks, press the only SPEAKERS A key
to the on position.