Kenwood KRF-V8030D - Manual (Page 42)

42
Remote Control
Remote control unit
In case of difficulty
Cause
• The batteries are nearing exhaustion.
• Subwoofer is OFF.
• No setup codes registered at for the respec-
tive input(s).
• The remote control is set to a different
operation mode.
• Batteries are exhausted.
• The remote control unit is too far away from
the main system, controlling angle is too
large, or there is an obstacle between the
receiver and the remote.
• The audio cords and system control cords are
not connected properly.
• No software is loaded in the source
component.
• An attempt is made to play a tape which is
being recorded in the cassette deck.
• The remote control has not been set to the
operation mode for the component you wish
to control.
• The microprocessor of the remote control
malfunctions.
Remedy
• Replace with new batteries to preserve the
currently registered setup information. $
• Turn the subwoofer ON. %
• Register a setup code or Non-IR code at the
respective input(s). RC 3
• Press the MUSIC , MOVIE , or TV keys to
select the appropriate operation mode.
• Replace with new batteries. $
• Operate the remote control unit within the
controllable range.
• Connect properly referring to “Setting up the
system”. 8
• Place software in the source component you
want to play.
• Wait until recording has completed.
• Press the MUSIC , MOVIE , or TV keys to
activate the operation mode for the
component you want to control before
operation.
RC 5
• Reset the microprocessor. §
Symptom
The battery indicator flashes during opera-
tion.
Subwoofer volume cannot be adjusted.
Certain inputs cannot be selected using the
remote control.
Remote control operation is not possible.
For your records
Record the serial number, found on the back of the unit, in the spaces
designated on the warranty card, and in the space provided below. Refer
to the model and serial numbers whenever you call upon your dealer for
information or service on this product.
Model __________________ Serial Number ________________________