Krown Manufacturing Model Krown 100 - Manual (Page 14)

HOW TO MAKE A TDD CALL BY USING ACOUSTIC CUPS
1. Turn ON the Krown 100.
THE TWO-LINE DISPLAY WINDOW WILL SHOW KROWN 100
2. Place telephone receiver down firmly in the rubber acoustic
cups with telephone cord on the LEFT.
3. If the Phone Light is on and steady, there is a dial tone.
Dial the telephone number now on your telephone, not on
the Krown 100.
If the phone is not steady nor flashing, your phone
extension may be in use by someone else.
4. Watch the Phone Light after you dial the number. If the light shows:
1. SLOW FLASHING = Telephone is RINGING at the number dialed.
OR
2. FAST FLASHING = Line is BUSY at the number dialed
OR
3. IRREGULAR FLASHING = (1) Your call cannot be completed as dialed. Hang up,
check number and try again, or call the TDD Operator for assistance.
(2) The number is voice only.
(3) Your call has been answered by an answering machine.
5. The incoming messages are printed in upper case (CAPITAL) letters.
Outgoing messages are printed in lower case (small) letters.
6. The logo on top of the TDD shows how to position the phone handset.
7. Unplug the Direct Connect line when you use the Acoustic phone call.
TELEPHONE CONVERSATIONS
1. When someone answers your TDD call with his/her TDD, the person’s response will end with GA
(Go Ahead). You now type back. Pressing the GA key is like saying, “Okay, it’s your turn to talk now.”
2. When both people are ready to hang up, press the SK key (instead of GA) or GA to SK. This means
“Stop Keying.” When both have typed SK the conversation is finished. Hang up the telephone by
putting the handset back on the phone. Turn the power switch off.
II
11
USING YOUR KROWN 100