Kompernass KH 6502 - Manual (Page 13)

- 11 -
MultiMediaCard- /SecureDigital memory cards (MMC/SD)
MultiMediaCard/SecureDigital memory cards must be inserted into the memory
card slot. Insert the MMC/SD memory cards with the contacts forward and
slide them straight into the memory card slot.
Thereby...
- the side of the memory card with the contacts must face down and
-
the slanted corner of the memory card must be on the right side
USB memory sticks (USB)
The DVD player supports USB memory sticks 1.1 and 2.0 up to a capacity
of 1GB.
USB memory sticks must be inserted into the USB port.
• Press the USB/CARD button on the remote control or the USB/SD/MMC CARD
button on the device until the message READ USB appears in the display.
This procedure also applies to particular memory cards.
Note:
If the memory card or USB memory stick does not contain any playable
data the memory card and/or USB function is not selectable.
13.3 Removing memory cards/USB memory sticks
Memory cards/USB Memory sticks should only be removed after the memory
card/USB slot is deactivated. Thus avoiding the possibility of damage or
data loss.
•
Press the USB/CARD button on the remote control several times or the
USB/SD/MMC CARD button on the device until the message DVD appears
in the display to return to the DVD mode.
• You can now remove the memory card/USB memory stick from the
memory card/USB slot.
14. Playing back DVDs, VCDs or S-VCDs
To play back a DVD/VCD/S-VCD with the DVD player...
•
Make sure that the DVD player is ready for operation.
• Switch the DVD player on.
When the DVD player and other potentially connected devices (i.e. an audio
component) are ready for operation and are switched on you will now see
the Silvercrest logo in the display.
• Open the disc tray on the front panel of the DVD player by pressing the
button
"Open/Close" on the front panel of the DVD player or on the
remote control.
Open will appear in the display.
• Insert a DVD/VCD/S-VCD disc in the disc tray with the inscribed/labled
side up.
• Press the OPEN/CLOSE button on the front panel of the DVD player or on
the remote control again to close the disc tray.
Close shows in the display while the disc tray is closing.
• The contents of the inserted DVD/VCD/S-VCD will now be loaded; this
may take a few seconds. In the meantime Loading will appear in the
display.
• Playback of the inserted DVD/VCD/S-VCD starts automatically.
Note:
DVDs, VCDs and S-VCDs, that you want to playback with the DVD player
possibly have a country code, which is printed on the DVD cover.
The DVD player can only playback DVDs/VCDs/S-VCDs with the country
code 2.
If no country code is printed on the cover of a DVD/VCD/S-VCD...
• but instead the symbol , then the DVD/VCD/S-VCD can be played
back with the DVD player
• then the DVD/VCD/S-VCD can possibly not be played back with the
DVD player. You can check this by attempting to play back the DVD.
Depending on the inserted DVD/VCD/S-VCD it is possible that the contents
of the DVD/VCD/s-VCD will not playback immediately, rather first a selection
menu appears in the display.
In this event select the menu option which will start the playback of the film
with the control button
on the remote control.
• To begin playback of the film press the PLAY/PAUSE button.
Play is shown briefly in the display.
IB_KH6502_EN_LB3.qxd 07.12.2007 8:46 Uhr Seite 11