Kompernass KH 6502 - Manual (Page 5)

- 3 -
4. Operating elements
A. DVD player front panel
q
Volume control
w Headphone output 3,5 mm
e FUNCTION switch: Switch the device off, switch to DVD or radio operation
r DISPLAY button: Display playback information
t LCD display
y STOP button
USB/SD/MMC CARD button: Stop playback/Display USB/
Memory card contents
u Carrying handle
i Band selection switch
o Frequency control
a PLAY/PAUSE button
s SKIP UP button: move forward a title/chapter, fast forward
d SKIP DOWN button: move back a title/chapter, fast rewind
f Loud speaker
g IR sensor for the remote control
h Memory card slot for SD and MMC cards
j Disc tray
k USB slot
l OPEN/CLOSE : Open/Close the disc tray
; MIC VOL : Microphone volume control
2) MIC : Microphone input 3,5 mm
2! AUDIO IN : Stereo audio input 3,5 mm
2@ FM ST. : Indicator for FM stereo reception (green light shows stereo reception)
2# POWER : Power indicator (green light shows when device is switched on)
2$ AUDIO button: Set the audio language/channel
2% REPEAT button: Set the repeat function
2^ MENU button: Access disc menu
B. DVD player rear panel
2&
Rear speaker
2* Telescopic antenna
2( Battery compartment
3) VIDEO : Composite video output
3! AUDIO OUT R : Right audio output
3@ AUDIO OUT L : Left audio output
3# Power cable connector
C. Remote control
q
OPEN/CLOSE : Open/Close the disc tray
w MENU : Access disc menu
e SETUP : Access the OSD menu
r DISPLAY : Superimpose disc information
t STOP : Stop playback
y PLAY/PAUSE button, OK button: Start/Pause playback, confirm input
u SUBTITLE : Set the sub-title
i Number buttons
o AUDIO : Set the audio language/channel
a SEARCH : Access the search function
s REPEAT : Set the repeat function
d ZOOM/SLOW : Set image enlargement, slow motion function
f USB/CARD : Playback of USB or memory cards
g Battery compartment (on the rear panel)
h MUTE : Switch the sound on/off
j ANGLE/PROGRAM : Change the camera perspective/
Access the programme function
k Control buttons
l SKIP UP: move forward a title/chapter, fast forward
SKIP DOWN : move back a title/chapter, fast rewind
; TITLE : Access the title menu
2) SCREEN ON/OFF : Switch the LCD display on and off/
set the brightness and colour
5.Setting up of the DVD player
1. Carefully remove the DVD player and the supplied accessories from
the packing.
2. Remove the protective foil from the LCD display.
3. Place the DVD player on a flat, even and firm base.
4. Plug the DVD player's power cord in the power cord connector on
the rear panel of the DVD player.
Attention!
If you want to connect the DVD player to other devices do not plug the
power cord into the mains power at this time. Wait until you have con-
nected the other devices.
In the event that you wish to change the type of video or audio connec-
tion you must first pull the power plug from the power socket! Otherwise
the DVD player and possibly equipment connected to it could become
irreparably damaged through voltage peak strikes!
6. Safety instructions
• This device is not suitable for children or other persons, whose physical,
sensorial or mental abilities, without assistance or supervision, impede the
safe operation of the device. Children should be watched-over to ensure
that they do not play with the device
• To avoid unintentionally switching on the device pull the power cord
from the mains supply after use and before cleaning.
• Check the appliance and all parts for visible damage.The safety concept
can work only if the appliance is in a faultless condition.
• The power plug must always be easily accessible, so that the appliance
can be quickly separated from the mains in the event of an emergency.
Risk of electrical shocks.
• Connect the appliance only to correctly installed and earthed mains sockets.
Ensure that the rating of the local power supply tallies completely with
the details given on the rating plate of the appliance.
• Arrange for defective power plugs and/or cables to be replaced at
once by qualified technicians or our Customer Service Department.
• Arrange for customer service to repair or replace connecting cables
and/or appliances that are not functioning properly or have been
damaged.
NEVER submerse the appliance in water. Wipe it only with a slightly
damp cloth.
• Do not expose the appliance to rain and never use it in a humid or wet
environment.
• Ensure that the power cable never becomes wet during operation.
• You must not open the housing or repair the appliance yourself. Should
you do so, appliance safety can no longer be assured and the warranty
will become void.
• Protect the appliance against drip and spray water. Do not place any
water-filled vessels (e.g. flower vases) on or near the appliance.
IB_KH6502_EN_LB3.qxd 07.12.2007 8:46 Uhr Seite 3