Kompernass KH 6502 - Manual (Page 9)

- 7 -
11. Radio functions
The LCD display remains switched off during operation of the radio.
1. Set the FUNCTION switch to the RADIO position.
2. Lift the telescopic antenna and pull apart. Adjust the antenna positioning
so that radio reception is optimal.
A reception antenna for receiving MW (AM) transmissions is built into the
unit. In radio operation, turn the whole appliance to a position where the
best radio reception is obtained.
3. Adjust the reception range (AM/FM/FM ST.) with the waveband selector.
With the adjustment to FM ST FM ST, radio programmes transmitted in
stereo will be played back in stereo. If the programme is received in
stereo with full signal strength the FM stereo message
FM ST. lights up.
Note:
Should the stereo signal in the reception range FM ST be too weak,
you can improve it by selecting the adjustment FM. In this adjustment
the sound is played in Mono.
4. Set to the desired radio station by turning the frequency knob.
12. DVD player functions
• Set the FUNCTION switch to the DVD/USB/CARD position.
The LCD display switches on and the background image appears.
Setup menu in DVD mode
Note:
In these instructions the English setup menu is described. At any time
you can set the menu to your countrys language as described in
"Language Setup > OSD Language".
In the DVD mode you can access a settings menu, in which you can implement
image and sound settings as well as activate other functions. When you carry
out changes in the setup menu, these changes are saved even when the device
is switched off.
• You can set the default settings at any time in the SYSTEM SETUP > DEFAULT
menu.
• The setup menu can be accessed during playback.
The setup menu subdivides into the following menus:
• SYSTEM SETUP
• LANGUAGE SETUP
• VIDEO SETUP
• SPEAKER SETUP
Navigating in the menu
1. Press the SETUP button to access the Setup menu. The main menu
SYSTEM SETUP appears.
• With the control buttons and the OK button you can carry
out all the settings in the menu.
2. With the control buttons you can select a menu by moving the yellow
mark under the corresponding menu symbol.
3. With the control buttons you can select an input in a menu by moving
the yellow bar over an input.
4. With the control button you can alternate in the sub menu of an in-
put and with the control button you can move back a menu level.
5. To confirm a selection press the OK button.
All navigation possibilities in a current menu are displayed at the lower edge
of the menu.
Exiting the Setup menu (EXIT SETUP)
• You can exit the Setup menu at any time by pressing the SETUP button again.
SYSTEM SETUP
TV SYSTEM
LCD MODE
TV TYPE
PASSWORD
RATING
DEFAULT
EXIT SETUP
IB_KH6502_EN_LB3.qxd 07.12.2007 8:46 Uhr Seite 7